CROWN ROCK MASTER 30KGS

CROWN ROCK MASTER 30KGS is a cement based polymeric texture wall finish made from finest quality minerals, white cement and polymers.

Recommended use: Ideal for decorating and protecting interior and exterior walls.

Substrates: New or previously painted (sound) plaster, concrete and cement rendering.

Advantages: Crown RockMaster is highly compatible with cementitious surfaces. Hides surface undulations and cracks. Tough textured and durable. Protects walls and plasters from heavy rains and wind. Resistance to algae and fungus. Excellent UV resistance, good workability and high durability.

Conditions during application: The temperature of the substrate should be minimum 10°C and at
least 3°C above the dew point of the air, measured near the substrate. Good ventilation is required in
confined areas to ensure proper drying.

Crown RockMaster Product Description:
Colour Range: White to pale cream base which can be top coated with over 11,200 shades in
water based finishes from our Dispensing Unit

Pack Sizes: 30kg. 5kg for samples only Finish: 1mm, 2mm and 3mm textured variants finishes

Shelf Life: 12 months if stored under cool and dry conditions.

Thinner & equipment cleaner: Water
Mixing Ratio: 150 to 200ml water for every 1kg of powder (4.5 – 6L water per 30kg bag of powder)

Mixing:
• Take 150 – 200ml water for every 1kg of Rockmaster powder in a clean plastic container.
• Add the Rockmaster to the water (NOT water to powder) slowly while stirring.
• Mix with a handheld electric mixer (recommended) or by hand till homogeneous lump free
paste.
• Allow resultant paste to stand for 5 – 10 minutes for additives to dissolve completely.
• Remix again for about 2 minutes. The mixture is now ready to be applied.
Pot-life: 60 – 80 minutes maximum. Mix only enough quantity to be applied within 2 hours

Film thickness: 1mm to 3mm depending on variant
Drying Times: Surface dry: 1 hour max. Recoatable/ Hard Dry: 8 hours max

APPLICATION DATA: The product can be applied by: STAINLESS STEEL trowel and finished
with a special plastic trowel or comb to create the final design texture e.g., Horizontal, Vertical,
Circular etc.
Crown provides a SUPPLY & APPLY service for this product. Contact our Call Centre for
more details.

Spreading Capacity per coat: Depends on film thickness applied, a variant of texture, surface porosity, surface imperfections, temperature & wastage during painting.
8 – 9 m²/ 30kg per coat for 3 mm variant.
9 – 10 m²/ 30kg per coat for 2 mm variant.
11 – 12 m²/ 30kg per coat for 1 mm variant.

The maximum spread rate per coat is obtained at minimum dry film thickness and vice versa.

Surface preparation & Application
• Dampen the surface to be plastered with clean water. Allow excess water to drain off
• Once the surface is clean, apply Rockmaster with a Stainless-steel trowel on the prepared
plaster surface.
• Leave the surface to dry for 10 minutes.
• Make the desired pattern using a plastic/ fibre trowel and move uniformly on the surface to
get the desired texture pattern and uniform levelling.
• Allow full curing (minimum 8hrs) then apply a suitable water-based topcoat of desired colour.

Precautions:
1. Ensure surface where Rockmaster is to be applied is plain and leveled.
2. Avoid applying Rockmaster on surfaces which are subjected to continuous dampness.
3. Recommended: Use the material mix within 2 hours after adding water.
4. While mixing or applying Rockmaster, we recommend wearing of protective clothing and eye goggles to
avoid dust entering the eyes.